Normally, I tend to prefer small looms, but I have just fallen in love with using loom extender bars on the Mirrix loom.
It’s really hard to convey how tall the ‘Alice in Wonderland’ version of the Big Sister 16 inch loom is when she’s got her stilts on.
With the extenders, she is 40 inches/1 m tall.
Now, that’s tall!
This means that you can achieve lots more weaving with one warp up.
(I’m working on some really fun stuff with my Big Sister Stiltie! So, stay tuned!)
My husband bought me the components for the extenders at the place he buys parts for our ancient tractor, so I didn’t have instructions on how to do this.
So, I had to figure it out for myself.
I found that there are a few tricks that make the set up easier when adding the loom extenders to your Mirrix loom.
First, lift the top of the loom off the side rails and set aside.
Unscrew the thumbscrews from the threaded rods, and screw them onto the extension rods.
I screwed them on so they were 5 inches/12.5 cm from the top end of the extensions.
Put the washers back on top of the thumbscrews.
Screw the coupler to the top of the loom rod.
Hot tip: Place the end of a tape measure inside the coupler so you can watch to see that you have screwed it on so it is half way onto the lower rod.
I had my doubts about how stable this was going to be, because the coupler seemed wobbly to me.
But, I went ahead, and screwed the extension rod in anyhow….
And, then, when I tightened it up by hand, I was amazed at how it was suddenly rock solid!
This is good!
Repeat for the other side…
Measure to be sure you have everything square, and put the top half of your loom back on.
Stand back in amazement at your loomie on stilts! Wowsa!
The best part is that the loom is still miraculously stable and works perfectly.
I find that resting it against the edge of the desk and having the lower edge sitting in my lap is the most comfortable way to weave with the extensions on.
Also, weaving standing up works well.
Having the stand for it would be sublime.
I made a video of the ‘putting it together’ process: